Filter
Top Products
G.SHDSL Port Configuration window 108
Models 2616RC, 3096RC & 3196RC Admin Reference Guide 9 • G.SHDSL (Model 3096RC)
Figure 45. Color-coded port status example
Color-coded port status indicators
The G.SHDSL port status table uses the following color-codes (see figure 45) to indicate the status of
each port:
• Green—The port is currently in dataMode(1) state. A G.SHDSL link is established with the remote CPE.
The link is ready and able to transfer data.
• Blue—The port is operating in one of the following test modes
- localLoop(6)
- remSerLoop(8)
- remEthLoop(11)
- lineLoop(10)
• Yellow—One of the following is occurring:
- The port is currently in training(2) state and the 4-minute link establishment timer has not expired
- The port is in deactivating(3) state
- The port is in downloading(4) state
• Orange—The port is in training(2) state and could not establish the G.SHDSL link (move to dataMode(2)
state) within 4 minutes.
• Red—The port is currently in error(5) state (see section “State (gshDSLState)” on page 107)
Desired State (gshDSLDesireState)
Configurable. Indicates the T-DAC operator’s current intentions for the port.
• idle(0)—Default value. The T-DAC operator intends the port for future use. Use this value when the port is
not currently connected to a remote CPE modem.
• dataMode(1)—The T-DAC operator intends the port to be connected to a remote CPE modem for current
active use
Test Mode (sDSLTMSelection)
Configurable when the value of port State is one of the following:
• dataMode(1)
• localLoop(6)