Filter
Top Products
PPP-IPCP Chassis Management Channel 165
Models 2616RC, 3096RC & 3196RC Admin Reference Guide 11 • In-band management
After the channel is UP, the In-Band Mgmt web page should appear similar to figure 96.
Figure 96. Defined In-Band Management Channels
The definitions of various columns are similar to the T1/E1 management channel described previously. For
Chassis Management Channels, only PPP is used. Frame Relay is not needed.
The Interface Type is H.110 TX /H.110 RX.
The statistics of the in-band management link are accessible via two paths. The first path is to click on the
hyperlink in the Status column. For the second, click on the hyperlink in the Interface Type, then click on the
hyperlink in the Statistics column.
Example 2: Bridged PPP (BCP) Chassis Management Channel
This example is to make a bridged-PPP chassis management channel between two Patton T-DACs. The chan-
nel will be:
Figure 97 shows how to configure the Model 2616RC for establishing a chassis management channel over the
midplane bus to the 3096RC in the same chassis.
Figure 97. Define an H.110 Management Channel
1. The management channel will appear in the table as shown in figure 98. Notice that the Status is DOWN
since the other end of the PPP link has not been created. We need to change the Protocol Type from IPCP
to BCP.
Model 2616RC
to
Model 3096RC
Name: to3096RC Name: to2616RC
BCP BCP
IP Address: +10.10.1.2/32 IP Address: 10.10.1.3/32
2616RC 3096RC
Tx: H.110 Port 1:1 --------> Rx: H.110 Port 1:1
Rx: H.110 Port 2:1 <-------- Tx: H.110 Port 2:1
Check Default Gateway box.