Filter
Top Products
IP Routing Overview window 190
Models 2616RC, 3096RC & 3196RC Admin Reference Guide 12 • IP (IP, TCP, UDP, & ICMP)
Entry Reassembly Maximum Size (ipAdEntReasmMaxSize)
The size of the largest IP datagram which the T-DAC can re-assemble from incoming IP fragmented datagrams
received on this interface.
IP Routing Overview window
The IP Routing Overview window (see figure 107) displays information required to route IP datagrams, includ-
ing the IP address, subnet mask, next-hop router, and interface for each network interface defined in the DACS.
Figure 107. IP Routing Overview window
The following paragraphs describe the contents of the IP Routing Overview window.
The IP Routing Overview window also provides a link to the IP Routing Table window. The IP Routing Table
window displays the IP forwarding parameters that the T-DAC’s operating system uses to make IP forwarding
decisions. (see “IP Routing Table window” on page 194).
Defined Routes
The following sections describe the defined routes displayed on the IP Routing Overview window.
Destination (genRouteDest)
The destination IP address of this route. An entry with a value of 0.0.0.0 is considered a default route. Multiple
routes to a single destination can appear in the table, but access to such multiple entries is dependent on the
table-access mechanisms defined by the network management protocol in use.
Each IP address displayed in the Destination column of the table also functions as a link to the Route Destina-
tion window. To view or modify next-hop routing information for a selected destination address, click on the
Address hyperlink in the Destination column. For more information about modifying next-hop routing infor-
mation settings, refer to “IP Route Details window” on page 193.