Filter
Top Products
G.SHDSL Port Details window 126
Models 2616RC, 3096RC & 3196RC Admin Reference Guide 9 • G.SHDSL (Model 3096RC)
- Active—The switch is toggled to the bottom position. The 3086 is operating in Remote Loopback mode
as shown in figure 60.
Figure 60. CPE remote loopback
Saving your work
Once you have defined your desired values for of the configurable parameters shown in the G.SHDSL port
configuration tables, you must click the Submit button (see figure 56 on page 121) to save your settings into
volatile DRAM. Once you click the button, the T-DAC will implement the new parameter values immedi-
ately.
Note
To save your changes permanently (i.e. through a power cycle), you
must visit the T-DAC HOME page, and click the Save Current Con-
figuration button. When you click the Save Current Configuration
button, the T-DAC will copy the configuration currently stored in vol-
atile DRAM into non-volatile Flash memory for permanent storage.
Hard Reset This Port button
When you click the Hard Reset This Port button (see figure 56 on page 121), the T-DAC will reset the port
hardware for the G.SHDSL port indicated in the page title. When the value of State for this G.SHDSL port is
error(5) (displayed on the G.SHDSL Port Configuration page), you can click this button to clear the error condition
for the port.
3196RC
Data stream
CPE
DSL line