Filter
Top Products
Ethernet Configuration window 88
Models 2616RC, 3096RC & 3196RC Admin Reference Guide 7 • Ethernet
Other Errors (dot3StatsInternalMacTransmitErrors)
The number of frames transmission on a fails due to an internal MAC sublayer transmit error.
Carrier Sense Errors (dot3StatsCarrierSenseErrors)
The number of times that the carrier sense condition was lost or never asserted when attempting to transmit a
frame on a particular interface.
Received Frames Too Long (dot3StatsFrameTooLongs)
The number of frames received that exceed the maximum permitted frame size.
Other Received Errors (dot3StatsInternalMacReceiveErrors)
The number of frames in which reception fails due to an internal MAC sublayer receive error.
Chip Set ID (dot3StatsEtherChipSet)
Ethernet-like interfaces are typically built out of several different chips. This value identifies the chip set that
gathers the transmit and receive statistics and error indications.
Ethernet Configuration window
The Ethernet Parameters section of the Ethernet Configuration window (see figure 33) enables you to make
changes to the Ethernet configuration. To reach this window, select Modify Parameters from the Ethernet Over-
view window (see figure 31 on page 85).
Figure 33. Ethernet Configuration window
The following sections describe each parameter.
State (boxEtherAState)
Indicates the state of the Ethernet interface. The following states are valid:
• notInstalled(0)—Ethernet interface is not physically present
• noLinkIndication(1)—no cable is connected to Ethernet interface. Hub is not seen.