Filter
Top Products
G.SHDSL Port Details window 122
Models 2616RC, 3096RC & 3196RC Admin Reference Guide 9 • G.SHDSL (Model 3096RC)
Note
The Line Provision Rate parameter label also functions as a hyperlink.
Click the Line Provision Rate hyperlink to open the G.SHDSL Line
Provision window (see “G.SHDSL Line Provision window” on
page 129).
• Clock Mode (gshDSLClockMode)—Indicates whether the clocking for this G.SHDSL link is provided and
controlled by the T-DAC or the remotely connected CPE device.
• Payload Rate (gshDSLPayloadRate)—Defines the payload rate (i.e. data rate as opposed to line rate) for
this G.SHDSL link. The following values of Payload Rates may be defined for T-DAC G.SHDSL ports:
Note
If the Payload Rate has been configured for either r64(1) or r128(2),
the DSL link will establish at 192 kbps. The 3096RC will then con-
figure the lower payload rate using EOC, a process which may take
up to 2 minutes. The CPE will then retrain. It will properly pass data
only after the link comes up the second time.
• # of I-Bits (gshDSLIbitSel)—Defines the number of I bits transmitted in each G.SHDSL frame. The fol-
lowing values may be defined:
- b0(0)
- b1(1)
- b2(2)
- b3(3)
- b4(4)
- b5(5)
- b6(6)
- b7(7)
• Annex Type (gshDSLAnnexSel)—Defines the Annex type to be used on the link connected to this port.
The following values may be defined:
- annex-A(1)—Typically used in North America
- annex-B(2)—Typically used outside North America
• Transmit Power (gsDSLTxGain)—Enables you to increase or decrease the transmit power setting in 1-
decibel increments.
- r64(1) - r128(2) - r192(3) - r256(4) - r320(5) - r384(6)
- r448(7) - r512(8) - r576(9) - r640(10) - r704(11) - r768(12)
- r832(13) - r896(14) - r960(15) - r1024(16) - r1088(17) - r1152(18)
- r1216(19) - r1280(20) - r1344(21) - r1408(22) - r1472(23) - r1536(24)
- r1600(25) - r1664(26) - r1728(27) - r1792(28) - r1856(29) - r1920(30)
- r1984(31) - r2048(32)
- r2112(33) - r2176(34) - r2240(35) - r2304(36)