Filter
Top Products
When creating an L-Server for which only a configuration definition has been created, a physical server not allocated to the L-
Server can be selected from the list.
When the [Currently unusable] checkbox is checked, failed physical servers and physical servers that have inconsistencies in their
admin LAN network configurations are displayed in the list.
When the [Busy] checkbox is checked, the following physical servers are displayed in the list:
- Physical servers already allocated to other L-Servers
- Physical servers already assigned as spare servers
- Physical servers with an OS installed
Note
The [Select a Server Resource] dialog works as follows, depending on the configuration status of admin LAN network resources on
the NICs in the [General] tab or the [Network] tab.
- When admin LAN network resources are unset on the NIC
Depending on the selected physical server or the server pool, admin LAN network resources are automatically set on the NIC
configurations in the [General] tab or the [Network] tab.
For details on the resources automatically set, refer to the [General] tab or the [Network] tab.
- When admin LAN network resources have been set on the NIC
Physical servers or server pools matching the admin LAN network NIC configurations that are set on the [General] tab or the
[Network] tab are displayed.
When not filtering resources using admin LAN network settings, open the [Select a Server Resource] dialog after deleting the
settings.
Resource release
Specify whether to release the physical server allocated to the L-Server when the power is turned off.
If the [Automatic (when powered off)] checkbox is checked, the server is released when the power is turned off.
Note
When resources of the same servers are shared due to a change in usage, ensure that [Resource release] is set for the L-Server they are
allocated to.
When the server resources are allocated to the L-Server for which [Resource release] is not configured, the server resources cannot be
shared.
Boot Location
Decide whether the physical location of servers to be allocated to the L-Server can be changed.
When unselecting the [Automatic (when powered off)] checkbox of [Resource release], the location will be [Fixed].
- Fixed
Starts the L-Server on the same physical server that was operated last time.
- Relocate at startup
Automatically selects the optimal physical server when the L-Server is started.
Even when [Physical server] is specified, the L-Server may operate on a separate physical server from the second time it is started.
Server Recovery
Specify the server redundancy to allocate to the L-Server. To enable redundancy, select the [HA] checkbox.
- 173 -