Filter
Top Products
*3: When using VMware, the value to be reflected varies depending on the memory limit settings.
When Unlimited is set for the memory limit, the specified memory size is reflected.
When a particular value is specified for memory limit, that value is reflected.
When using Hyper-V, the value to be reflected varies depending on the dynamic memory settings.
When dynamic memory is enabled, the setting for the maximum memory is reflected.
When dynamic memory is disabled, the setting for the virtual machine memory is reflected.
*4: Updated only when VMware FT is configured or released.
When attaching and detaching disks from a virtual machine are performed consecutively on VM management software, an event log
regarding Storage Migration is output.
Note
Network information and physical L-Servers are not updated.
When attachment or detachment of disks is performed using storage management software, the changes to the configuration of storage on
the physical L-Server is not detected.
- For the created physical L-Server, reflect attachment or detachment of disks using the following procedure:
- When a Disk has been Attached
1. Detach the disk from the physical server using the storage management software.
When the physical server is powered on, it is necessary to change the status of the disk to detach into unused in advance.
2. Attach the disk to the physical L-Server.
For details, refer to "17.2.3 Attaching and Detaching Disks".
- When a Disk has been Detached
Detach the disk from the physical L-Server.
For details, refer to "17.2.3 Attaching and Detaching Disks".
- For a physical L-Server linked with a configured physical server, reflect attachment or detachment of disks using the following
procedure:
1. Cancel the link between the physical server and the physical L-Server.
For details, refer to "18.6 Releasing an L-Server".
2. Create a link between the physical server and the physical L-Server.
For details, refer to "17.8.1 Installation".
- Even if modification of the L-Server configuration failed, part of the information may be successfully modified. In this case, it takes
a while for the modified information to be reflected. The virtual machine information is reflected through periodic queries.
17.2.1 Modifying Specifications
This section explains how to modify L-Server specifications. Use the following procedure to modify L-Server specifications:
[Solaris Containers]
Calculate the cap value to configure for the non-global zone from the number of CPUs and the CPU performance.
For details, refer to "C.7.6 Creating an L-Server" in the "Setup Guide CE".
The Procedure when Using the GUI
1. Right-click the target L-Server in the orchestration tree, and select [Change Settings]-[Modify Specification] from the popup menu.
The [Modify an L-Server] dialog is displayed.
- 195 -