Filter
Top Products
When selecting the [HA] checkbox, the [Use a low spec server] checkbox of [Spare server specs], and <Select> of [Spare server pool]
will be enabled.
Spare server specs
This section specifies the selection method of spare server.
When the [Use a low spec server] checkbox is selected, physical servers with models matching that in the L-Server definition are
selected as spare servers.
For details on how to select a spare server, refer to "17.1.1 L-Server High Availability" in the "Operation Guide CE".
Spare server pool
Select the spare server pool.
Clicking <Select> displays the [Select a Server Resource] dialog.
Specify the server pool that the physical server to use for automatic switchover is registered in.
When a problem occurs on the physical server, recovery is performed by automatically switching to another physical server in the
same resource pool that is operating normally.
For details on how to perform switchover a spare server, refer to "17.1.1 L-Server High Availability" in the "Operation Guide CE".
Alive monitoring
Configure alive monitoring as enabled or disabled.
Address pool (WWN / MAC)
Select an address pool.
Clicking <Select> displays the [Select an Address Resource] dialog.
Select [Automatic] or [Pool]. The default is [Automatic].
When selecting [Pool], select from the registered address pool.
Specify the virtual WWN obtained from the I/O Virtualization Option and the address pool of the registered MAC address.
VIOM will be used for blades, and HBA address rename for rack mount servers.
Startup priority
With L-Servers, when performing batch power operations in a resource folder or a tenant, configure the priority for the L-Server.
Set a number between 1 and 256. Smaller values indicate higher priority. If omitted, "128" is set.
When not performing batch power operations, check the [Exclude from batch power operations] checkbox.
FC settings
FC connection pattern
If the number of FCs fitted or their location differs from physical server to physical server, specify an FC connection pattern file.
This setting can be made when the storage units are the following: For details, refer to "B.1 Creating Definition Files" in the "Setup
Guide CE".
- EMC CLARiiON Storage
- EMC Symmetrix DMX Storage
- EMC Symmetrix VMAX Storage
Note
When FC connection patterns are not displayed in the selection list, there are errors in the configuration file.
Review the configuration files for FC connection patterns, referring to "B.1 Creating Definition Files" in the "Setup Guide CE".
- 174 -