Filter
Top Products
Table 16.3 Correspondence Relationships of Network Information [Windows]
OS Information Information for L-Server Configuration
IP address specified for network
interface
(configured by a tenant
administrator)
Name of network
interface
Number of NICs
(number of NICs on the back side
of rack mount servers)
IP Address
192.168.1.1
Local area connection 1 1 192.168.1.1
192.168.2.1 Local area connection 2 2 192.168.2.1
Table 16.4 Correspondence Relationships of Network Information [Linux]
OS Information Information for L-Server Configuration
IP address specified for network
interface
(configured by a tenant
administrator)
Name of network
interface
Number of NICs
(number of NICs on the back side
of rack mount servers)
IP Address
192.168.1.1
eth0 1 192.168.1.1
192.168.2.1 eth1 2 192.168.2.1
Untagged VLAN
When not configuring a VLAN, check this checkbox.
Only one VLAN can be selected in the same NIC or NIC group.
Note
[Physical Servers]
The IP address to be allocated to a physical L-Server must be unique. An IP address is required for each L-Server used.
16.2.5 [OS] Tab
Enter the parameters to set for the OS when creating the L-Server. This setting is valid only if an image is specified in the [General] tab.
When using an L-Server with the server type [Physical], refer to "B.7 [OS] Tab Configuration" in the "Setup Guide CE".
16.3 Creation of Virtual L-Servers Using Parameters
This section explains how to configure a virtual L-Server with server, storage, and network specifications configured, without using an
L-Server template.
Specify the values on the following tabs:
- [General] Tab
- [Server] Tab
- [Disk] Tab
- [Network] Tab
- [OS] Tab
Use the following procedure to create L-Servers:
1. Right-click the target resource folder in the orchestration tree, and select [Create]-[L-Server] from the popup menu.
The [Create an L-Server] dialog is displayed.
- 178 -