Filter
Top Products
Note
If "2.4.2.2 Required Software" in the "Design Guide CE" is not installed, a new L-Server cannot be deployed on that VM host.
When using VMware, the virtual machine on a VM host which is not managed with VM management software can be linked to an L-
Server. Power operations (starting up, stopping, and restarting) and modification of basic information (label/comments) can be performed
for the L-Server.
When using Hyper-V, the virtual machine on a VM host which is not managed with VM management software cannot be linked to an L-
Server.
18.4 Installation
This section explains the installation method to link a configured physical server to a physical L-Server, and the installation method to
link a configured virtual machine to a virtual L-Server.
18.4.1 Preparations
Preparations
For details, refer to the procedure in "D.2 Preparations for Servers" in the "Design Guide CE".
Setup
Register the resources of configured physical servers and VM hosts to Resource Orchestrator.
When linking a configured physical server to an L-Server, perform the following procedure described in "Appendix B Configuration when
Creating Physical L-Servers" in the "Setup Guide CE":
When linking a configured virtual machine to an L-Server, perform the following procedure described in "C.2 VMware" or "C.3 Hyper-
V" in the "Setup Guide CE":
1. Register Resources
When linking a configured physical server to an L-Server, perform the following procedure:
a. Register Storage Management Software
b. Register Managed Servers
When linking a configured virtual machine to an L-Server, perform the following procedure:
a. Register VM Management Software
b. Register Managed Servers
2. Register Resources in Resource Pools
When linking a configured physical server to an L-Server, perform the following procedure to register a resource in a resource pool.
a. Register physical server resources in a server pool.
In the [Register Resources] dialog for the server pool, check the [Display servers with OS installed] checkbox and specify a
physical server with an OS installed.
b. Register the disks that are connected to the physical server to be linked with the L-Server in a storage pool.
c. Register address set resources.
Specify the scope including MAC/WWN addresses being used by the configured physical server.
d. Register network resources.
Specify IP addresses not being used by the configured physical server or the virtual machine.
- 234 -