Filter
Top Products
5. Confirm the configuration set in the [Network Settings] dialog.
6. Click <OK>.
VLAN settings are applied to the related LAN switch blade.
Note
The VLAN configuration of a registered LAN switch blade should be set from the ROR console instead of the LAN switch's own Web-
based and command-based interfaces.
If the Port VLAN ID field is left blank and a value is entered for Tagged VLAN ID in the [VLAN Configuration] dialog, the tagged LAN
only will be enabled. To enable a port VLAN, enter a value for Port VLAN ID.
When only a tagged VLAN is configured, the value for the port VLAN is not displayed on the ROR console even if it has been configured
on the switch. For the devices for which port VLANs cannot be deleted, it is necessary to limit the frames that let ports pass through to
the tagged frames only.
If the port VLAN ID is unspecified or 1, a tagged VLAN ID cannot be set to 1.
5.4.7 HBA address rename Settings
For details, refer to "5.5.3 HBA address rename Settings".
Point
When creating a physical L-Server using a blade server, HBA address rename settings are not necessary.
5.5 When using Rack Mount and Tower Servers
This section explains how to register resources when using rack mount or tower servers.
When using rack mount or tower servers, use the following procedure to register resources:
- Register Rack Mount or Tower Servers
- Register LAN Switches
5.5.1 Registering Rack Mount or Tower Servers
This section explains how to register a rack mount or tower server.
- 34 -