Filter
Top Products
- Deletion of a network device using the rcxadm netdevice delete command is not possible because the target network device cannot
be identified.
Refer to "9.4.2 Deleting LAN Switches and Network Devices" to delete the target network device.
- The intended network device may not be automatically configured.
- Disaster Recovery may fail.
- Under redundancy configuration, it is only enabled for the same vendor and model. For this reason, registration should be made
specifying the same group ID as the network device that has been already registered for redundancy configuration. During the
registration confirmation process, if the network device has a different vendor name and device name from the registered one,
registration as a network device will fail.
5.8 When using PRIMEQUEST Servers
This section explains how to register resources when using PRIMEQUEST servers.
- Registering Chassis (For PRIMEQUEST Servers)
- Registering PRIMEQUEST Servers
5.8.1 Registering Chassis (For PRIMEQUEST Servers)
By registering a chassis, every partition mounted in the chassis will be automatically detected and displayed as an unregistered server in
the server resource tree. Register these managed servers individually.
For details on registering servers, refer to "5.8.2 Registering PRIMEQUEST Servers".
Use the following procedure to register a chassis:
1. In the ROR console server resource tree, right-click [Server Resources], and select [Register]-[PRIMEQUEST] from the popup
menu.
The [Register Chassis] dialog is displayed.
2. To use this feature, the following settings must first be defined:
Admin LAN (IP address)
Enter the virtual IP address that was set on the chassis management board.
Enter the IP address using periods ".".
Chassis name
Enter a name to assign to this chassis.
Enter a character string beginning with an alphabetical character and containing up to 10 alphanumeric characters and hyphens
("-").
SNMP Community
Enter the SNMP community that was set on the chassis management board.
Either select [public] or enter an arbitrary string.
Enter a string of up to 32 alphanumeric characters, underscores ("_"), and hyphens ("-").
Remote server management
User ID
Enter the ID of a remote server management user account with administrative authority over this managed server.
This user ID must be between 8 and 16 alphanumeric characters long.
A user ID with at least administrator privileges within the remote server management must be specified.
Password
Enter the password of the above remote server management user account.
This password must be between 8 and 16 alphanumeric characters long.
- 46 -