Filter
Top Products
Configuring Authentication
Figure 5-3. The Authentication Services Page
The Authentication Services table shows the currently defined Authentication Services. This table shows
the following information about each Authentication Service:
Table 5-2. Authentication Services Table Contents
Column Description
Authentication Service The name of the Authentication Service
Service Type The type of the service
» To edit an Authentication Service, click the Authentication Service name in the first column of the table,
or click the pencil icon at the end of the row. This takes you directly to the Edit Authentication Service
page (see
“Configuring Authentication Services” on page 5-7).
Note: You cannot edit the built-in Authentication Service or the NT Domain Logons service. For
these two services, no configuration is needed.
» To delete a Authentication Service, click the trash can icon at the end of the row.
Note: You cannot delete the NT Domain Logon, 802.1x Logon, or Built-in Authentication Services.
You also cannot delete an Authentication Service that is in use–an error message will inform you if
this is the case.
» To create a new Authentication Service, click the New Service... button at the bottom of the
Authentication Services list. This takes you to the New Authentication Service page.
» To view the list of all Authentication Policies, click the Authentication Policies link directly under the
page name in the left-hand panel of the page.
Configuring an LDAP Authentication Service
To configure an Authentication Service, click the New Services... button at the bottom of the list on the
Authentication Services or New Authentication Policy pages. The New Authentication Services page
5-8 HP ProCurve Secure Access 700wl Series Management and Configuration Guide