Filter
Top Products
Command Line Interface
Note: This command is not available on an Integrated Access Manager.
Advanced Network Configuration Status
show bridging
Shows the current bridging settings.
The current bridging types that may appear are:
cdp Cisco Discovery Protocol
wnmp Wireless Network Access Protocol
atalk AppleTalk protocol
custom Type was set using a custom bridging string.
See —Bridging“ on page 6-24 in Chapter 6, and Appendix B, —Filter Expression
Syntax“ for a detailed discussion.
For example, output from this command, if bridging is enabled, is similar to the following:
Bridging is enabled
Configured bridges:
cdp: ether [12:2] <= 1514 and ether dst 01:00:0c:cc:cc:cc
wnmp: ether [12:2] = 0x8781 and ether[0:4] = 0x01a0f8f0
custom: ether[12:2] = 0x8037 or ether[12:2] = 0x8137
show clientprobes
Displays the current configuration of the client probe timers. Output from this command is similar
to the following:
Client probes
Interval: 30 seconds of idle time
Timeout: 300 seconds of idle time
show forwardipbroadcasts
Shows the list of ports or slots and ports that have IP broadcast forwarding enabled. For example,
output from this command for an Access Controller or Integrated Access Manager with 12 ports
appears as follows:
Enabled on: 1/1 1/2 1/3 1/4 2/1 2/2 2/3 2/4 3/1 3/2 3/3 3/4
Access Control Server Configuration
The following commands are available only on an Access Control Server or an Integrated Access
Manager in
cli ACS mode, except for the show syslogserver and show natdhcp commands, which are also
available on an Access Controller.
HP ProCurve Secure Access 700wl Series Management and Configuration Guide A-15