Filter
Top Products
Command Line Interface
Controller. To modify these settings on an Access Controller, you must use the Administrative Console
on the managing Access Control Server.
set snmp on | off
Turns SNMP support on or off. Turning SNMP on enables read-only access to the MIB.
Turning it on when already on, or off when already off has no effect. By default, SNMP support is
off.
set snmpport <port>
Sets the SNMP port. By default, the SNMP port is 161.
clear snmpport
Resets the SNMP port to the default, port 161.
add snmpmanager <hostname> | <ip-address> [/<mask>]
Specifies an authorized SNMP manager by hostname, IP address, or subnetted IP address that can
query for SNMP responses.
You can specify up to four authorized SNMP managers by repeating the
add snmpmanager
command. If you try to add a fifth manager, you will receive an error message.
<hostname> The hostname of an SNMP management system.
<ip-address> The IP address of an SNMP management system.
<maskbits> A subnet mask that defines a range of addresses for the SNMP
management system, specified as the number of bits in the mask.
For example, /30 is the equivalent of 255.255.255.252; /24 is the
equivalent of 255.255.255.0.
delete snmpmanager all | <hostname> | <ip-address> [/<mask>]
Deletes an authorized manager, or all of them.
set snmplocation <location>
Sets the SNMP sysLocation object defined in RFC 1213 as “the physical location of this node (for
example, telephone closet, 3rd floor).”
Note: You cannot set this object from an external manager via SNMP.
clear snmplocation
Clears the SNMP sysLocation object.
Note: You cannot clear this object from an external manager via SNMP.
HP ProCurve Secure Access 700wl Series Management and Configuration Guide A-35