Filter
Top Products
Command Line Interface
set snmpcontact <contact>
Sets the SNMP sysContact object, defined in RFC 1213 as “the textual identification of the contact
person for this managed node, together with information on how to contact this person.”
Note: You cannot set this object from an external manager via SNMP.
clear snmpcontact
Clears the SNMP sysContact object.
Note: You cannot clear this object from an external manager via SNMP.
set snmpcommunity <community>
Sets the SNMP read community string. The default is public. HP strongly recommends that you
change the community string. This is also used for traps.
clear snmpcommunity
Clears the SNMP community string.
add snmptrapreceiver <ip-address>
Specifies an IP address to receive traps.
You can specify two trap receivers, by executing this command twice. If you try to specify a third
trap receiver, you will receive an error message.
delete snmptrapreceiver all | <ip-address>
Deletes a specified trap receiver, or both trap receivers.
set snmpauthtraps on | off
Enables or disables the generation of authentication traps.
show snmp
Note: Even though you can only configure SNMP for an Access Controller from an Access Control
Server or Integrated Access Manager, you can use the show snmp command from an Access
Controller to view the SNMP settings.
Shows the current SNMPv1 configuration. Output is similar to the following example:
SNMP: Disabled
SNMP Access Mode: Read Only
Community Name: public
SNMP Port: 161
Location: ServerCloset Bldg2
Contact Info:
Device Name: 192.168.10.174
Authentication Traps: Enabled
A-36 HP ProCurve Secure Access 700wl Series Management and Configuration Guide