Filter
Top Products
Command Line Interface
show portip
Displays the current IP address and netmask settings, if set, for all ports in the system. Output from
this command is similar to the following:
Port settings
Slot 1 Port 1 IP: Not set
Slot 1 Port 2 IP: 192.168.5.1 Netmask: 255.255.255.0
Slot 1 Port 3 IP: 192.168.6.1 Netmask: 255.255.255.0
Slot 1 Port 4 IP: Not set
Slot 2 Port 1 IP: Not set
Slot 2 Port 2 IP: Not set
Slot 2 Port 3 IP: Not set
Slot 2 Port 4 IP: Not set
Slot 3 Port 1 IP: Not set
Slot 3 Port 2 IP: Not set
Slot 3 Port 3 IP: Not set
Slot 3 Port 4 IP: Not set
Access Controller Configuration
The commands in this section are available only on an Access Controller or an Integrated Access
Manager. The exceptions are the
set accesscontrolserver, clear accesscontrolserver, and show
accesscontrolserver
commands, which are not available on an Integrated Access Manager. None of these
commands are available on an Access Control Server.
Note:
To disconnect an Access Controller from an Access Control Server, you must first change the
shared secret then the Access Control Server IP address. If you change the Access Control Server IP
address without changing the shared secret, the synchronization function between the Access Control
Server and the Access Controller will reset the Access Control Server IP address back to the original
Access Control Server IP address.
set accesscontrolserver <ip-address>
On an Access Controller, sets the IP address of its Access Control Server or Integrated Access
Manager.
Note: This command is not available on an Integrated Access Manager.
clear accesscontrolserver
On an Access Controller, clears the Access Control Server or Integrated Access Manager IP address.
Note: This command is not available on an Integrated Access Manager.
show accesscontrolserver
On an Access Controller, shows the Access Control Server or Integrated Access Manager IP
address. Output from this command appears similar to the following:
Access Control Server: 192.168.2.15
A-14 HP ProCurve Secure Access 700wl Series Management and Configuration Guide