Filter
Top Products
Configuring the Network
Editing the Integrated Access Manager Configuration
The Integrated Access Manager is typically configured with its network configuration parameters and
shared secret when it is initially installed on the network, per the instructions in the Quick Start Guide or
Installation and Getting Started Guide shipped with the hardware.
However, there are several situations in which you may need to modify the Integrated Access Manager
configuration:
• To enable SSH access to the unit for remote CLI or Technical Support access
• To configure or change the shared secret used to establish a trust relationship between the Integrated
Access Manager and the associated Access Controllers.
Note: The shared secret is normally configured on the Integrated Access Manager at installation
through the CLI. However, an Integrated Access Manager configured to get its network parameters
through DHCP (the default) will boot up and run properly without a shared secret configured, but
separate Access Controllers will not be able to communicate with it. In this case, you must edit the
Integrated Access Manager configuration to add a shared secret to enable the Integrated Access
Manager to manage its associated Access Controllers. See
—The Access Control Server Shared
Secret“ on page 6-7 for more information about the shared secret.
» To ed
in the System Components List, or click the pencil icon (
it a Integrated Access Manager configuration, click on the name of the Integrated Access Manager
) to the far right of the Integrated Access
Manager.
6-8 HP ProCurve Secure Access 700wl Series Management and Configuration Guide