Filter
Top Products
Command Line Interface
show ip
Shows the current IP configuration. Output from this command looks similar to the following:
Hostname:
Domain Name: xyzcorp.com
IP address: 192.168.10.157/24
DHCP enabled: No
Default gateway:192.168.10.1
DHCP server: None configured
DNS servers: 192.168.2.248 192.168.2.205
WINS servers: None configured
set gateway <ip-address>
Sets the IP address of the default router.
clear gateway
Clears the gateway IP address (resets to 0.0.0.0). This is the equivalent of the command set gateway
0.0.0.0
.
set dhcp on | off
Enables dynamically-assigned IP address configuration for this system. If disabled the system's IP
address, subnet (netmask), gateway, and DNS servers must be set manually. The default (at factory
reset) is ON.
set dhcpserver <ip-address>
Note: This command is supported on the Access Control Server or Integrated Access Manager
only.
Sets the IP address to be used as a DHCP server for clients connected to an Access Controller that
does not use NAT.
<ip-address> The DHCP server IP address.
clear dhcpserver
Note: This command is supported on the Access Control Server or Integrated Access Manager
only. For an Access Controller, this function must be performed through the Administrative Console
on the managing Access Control Server.
Resets the currently configured DHCP server value.
show dhcpserver
Shows the currently configured DHCP server value, or “Not Set” if no DHCP server is configured.
A-10 HP ProCurve Secure Access 700wl Series Management and Configuration Guide