Filter
Top Products
Configuring the Network
uplink port so that the default uplink (slot 0 port 2 on a 700wl Series system) is now a downlink port,
then that port will appear on this page. The port being used as the uplink port will not appear.
To configure subnet addresses for Access Controller ports:
Step 1. On the Interfaces setup page select the Access Controller to configure.
Step 2. Click the Subnet tab.
The Subnet page for Access Controllers appears. See
Figure 6-18.
Figure 6-18. Interfaces: Subnet Settings Page
Step 3.
Configure the port settings as appropriate, by entering a starting IP address and selecting a
netmask from the drop down list in the Netmask field for each port.
Step 4. Click Save.
To restore the settings to the original default settings, click
Reset to Defaults.
To abandon your changes and revert to the current settings click
Cancel.
Note: There may be a short delay before these changes take effect.
Note: There are no restrictions on the IP addresses that can be used for port settings in relationship
to the Access Controller‘s IP address. However, your upstream routers must have static routes
HP ProCurve Secure Access 700wl Series Management and Configuration Guide 6-37