Filter
Top Products
Command Line Interface
Advanced Network Configuration
set natdhcp <ip-address> <subnetmask> [<lease-time> [<time-units>] ]
Sets the NAT DHCP subnet and lease time.
<ip-address> The DHCP subnet address for NAT. The default is 42.0.0.0
<subnetmask> The subnet mask, in the form xxx.xxx.xxx.xxx (e.g. 255.255.255.0). The
/<maskbits> form (e.g. /24) cannot be used in this command.
<lease-time> The length of time a lease remains valid, in units as specified by the time-units
parameter. Defaults to 86,400 seconds (one day).
<time-units> The time units in which the lease time is specified. Can be one of seconds,
minutes, hours, days, weeks, or months. Default is seconds.
clear natdhcp
Resets the currently configured internal DHCP server value used for NATed clients.
show natdhcp
Note: Even though you can only configure the DHCP server NAT address range from the Access
Control Server or Integrated Access Manager, you can use the show natdhcp command from an
Access Controller to view these settings.
Shows the currently configured DHCP server values for NATed clients. Output from this
command appears as follows for the default NAT DHCP configuration:
NAT IP Base: 42.0.0.0
NAT Subnet Mask: 255.0.0.0
Lease Time: 1 day
Remote Commands
The following commands are available only on an Access Control Server or Integrated Access Manager in
cli ACS mode. These commands allow the administrator to perform functions on a remote Access
Controller or peer Access Control Server through the CLI. The system at the specified IP address must be
one that the Access Control Server can manage—i.e. the remote system must be configured with this
Access Control Server’s IP address and shared secret.
remote ping <ip-address>
Pings the Access Controller at <ip-address> via the control channel.
remote cancel <ip-address>
Cancels the upgrade occurring on the Access Controller or secondary Access Control Server at <ip-
address>.
A-18 HP ProCurve Secure Access 700wl Series Management and Configuration Guide