Filter
Top Products
Command Line Interface
clear ntpserver
Clears the NTP servers IP address or hostnames. This command also disables the NTP service if it
was enabled.
set ntp on | off
Enables and disables the NTP service.
set datetime <date> <time>
Manually sets the current local date and time.
<date> The current date in yyyy/mm/dd format
<time> The current time in h24:mm format.
This command also disables the NTP service if it was enabled.
Caution: It is important that the system time be kept accurate, and the time should not be set
backwards, either manually or by NTP, while the system is in operation. A backwards change in
the time of day may cause certain internal time-outs to take longer than normal, and previously
expired and logged off users may be made to appear active, until the system moves beyond the
time these users logged off or had their rights expire. Therefore, if a backwards time change is
necessary (for example, to return from Daylight Saving Time to Standard Time) it should be
done during times when system usage is low to minimize any potential disruptions.
show time
Note: Even though you can only configure the time and timezone of an Access Controller from an
Access Control Server or Integrated Access Manager, you can use the show time command from
an Access Controller to view the time and timezone settings.
Shows the current date and time, configured time zone and NTP servers. Output from this
command is similar to the following:
Timezone: America/Los_Angeles
NTP Service: Disabled
NTP Servers: None
Time: 2002/11/26 17:22
SNMP Configuration and Reporting Commands
Note: The 700wl Series system supports MIB 2-compliant MIB objects.
Note: The 700wl Series system SNMP agent only provides read-only access to the MIB. Therefore,
you cannot set or clear MIB objects such as sysLocation or sysContact from an external manager via
SNMP. You must modify these objects through the web-based Administrative Console or the CLI.
The following commands are available only on an Access Control Server or an Integrated Access
Manager in
cli ACS mode, except for the show snmp command, which is also available on an Access
A-34 HP ProCurve Secure Access 700wl Series Management and Configuration Guide