Filter
Top Products
Command Line Interface
Translates to:
nslookup –timeout=10 <hostname>
ping {<ip-address> | <hostname>}
Pings an IP address or a hostname. If the hostname is not qualified, the domain name (as specified
by the
set domainname command) is appended.
Translates to:
ping –c 3 <ip-address>
or
ping –c 3 <hostname>
debug ip [ <slot>/<port>]
Shows IP traffic on an interface. The default (no slot/port specified) is the configured uplink.
<slot>/<port> The slot and port for which IP traffic should be displayed.
This command translates to:
tcpdump –en –i <interface> ip
This command displays tcpdump output until you terminate the command with a CTRL-C. Upon
termination, the console session is restarted, and you must log in again.
debug interface [ <slot>/<port> ]
Shows traffic on an interface. The default (no slot/port specified) is the configured uplink.
<slot>/<port> The slot and port for which traffic should be displayed.
This command translates to:
tcpdump –en -i <interface>
This command displays tcpdump output until you terminate the command with a CTRL-C. Upon
termination, the console session is restarted, and you must log in again.
debug tcpport <tcp port> [ <slot>/<port> ]
Shows specified TCP port traffic on an interface. The default (no slot/port specified) is the
configured uplink.
<tcp port> The TCP port number that identifies the traffic to be watched.
<slot>/<port> The slot and port for which IP traffic should be displayed.
This command translates to:
tcpdump –en –i <interface> tcp port <port>
This command displays tcpdump output until you terminate the command with a CTRL-C. Upon
termination, the console session is restarted, and you must log in again.
A-32 HP ProCurve Secure Access 700wl Series Management and Configuration Guide