Filter
Top Products
Command Line Interface
set dns <primary-ip-address> [<secondary-ip-address>]
Note: This command is supported on the Access Control Server or Integrated Access Manager
only. For an Access Controller, this function must be performed through the Administrative Console
on the managing Access Control Server.
Sets the IP addresses of the DNS servers.
<primary-ip-address> The IP address of the primary DNS server for the system.
<secondary-ip-address> The IP address of the secondary DNS server for the system (optional).
clear dns
Note: This command is supported on the Access Control Server or Integrated Access Manager
only. For an Access Controller, this function must be performed through the Administrative Console
on the managing Access Control Server.
Clears the IP addresses of the DNS servers.
set sharedsecret [<secret> <secret> ]
Sets the shared secret used to validate a connection between an Access Controller and Access
Control Server. Prompts for the secret if not entered on the command line.
Note:
Once a connection has been established between an Access Controller and its Access Control
Server (or Integrated Access Manager), changing the shared secret on either unit does not disrupt
this communication. To disconnect an Access Controller from an Access Control Server, you must
both change the shared secret and change the Access Control Server IP address configured in the
Access Controller.
clear sharedsecret
Clears the shared secret.
show sharedsecret
Shows whether the shared secret is set. The shared secret itself is not displayed. Output from this
command is as follows:
Shared secret: Set
or
Shared secret: Not Set
set wins <primary-ip-address> [<secondary-ip-address>]
Note: This command is supported on the Access Control Server or Integrated Access Manager
only. For an Access Controller, this function must be performed through the Administrative Console
on the managing Access Control Server.
HP ProCurve Secure Access 700wl Series Management and Configuration Guide A-11