Filter
Top Products
Configuring the Network
configured to support routing the addresses you have configured for your ports through the Access
Controller uplink port.
For example, if the Access Controller’s IP address is 192.168.2.20 with subnet mask 255.255.255.0 (/24)
and you configure a port to use 192.168.6.0 with mask /24, you must configure your router with a static
route that routes the 192.168.6.x addresses to 192.168.2.20. You can typically do this with a command
similar to:
ip route 192.168.6.0 255.255.255.0 192.168.2.20
Configuring SNMP
Simple Network Management Protocol (SNMP) is a standard for network management. SNMP enables
network administrators to remotely manage the equipment on their networks.
The 700wl Series system SNMP module enables 700wl Series system components to be monitored via
SNMP from a network management application such as HP OpenView or Aprisma SPECTRUM.
Note: The 700wl Series system supports Management Information Base-2-compliant objects. The four
HP ProCurve Secure Access 700wl Series MIBS are available from the Software and Downloads
section of the HP ProCurve support web site at www.hp.com/go/hpprocurve. The four MIBS are:
HP-BASE-MIB.txt, HP-SYSTEM-MIB.txt, HP-IF-EXT-MIB.txt, and HP-MEMPROC-MIB.txt.
To configure SNMP for the 700wl Series system:
Step 1. Click the SNMP tab from any page in the network configuration module.
The SNMP page is displayed, as shown in Figure 6-19.
6-38 HP ProCurve Secure Access 700wl Series Management and Configuration Guide