Filter
Top Products
Configuring the Network
Table 6-4. Edit Access Controller page fields
Field/Checkbox Description
Name An alphanumeric name for the Access Controller. By default the
name is the IP address of the unit.
IP Address The IP address of this Access Controller (read-only). This can be
changed under the Network Setup tab.
MAC address The MAC address of this Access Controller (read-only). This can be
changed under the Network Setup tab.
NAS-ID/Description A description for this Access Controller. If using RADIUS accounting,
this is used as the NAS-ID and is sent to the RADIUS server as part
of the accounting information. (If you do not enter a NAS-ID, the
MAC address of the Access Controller is sent instead.) See —Using
RADIUS for Accounting“ on page 5-20 for more details about the
RADIUS accounting feature.
Admin Username The built-in administrator username for this Access Controller. The
default is admin. The name can be up to 50 characters.
Admin Password The built-in administrator password for this Access Controller. The
default is admin. The password must be at least one (non-blank)
character in length (a minimum of 5 is recommended).
Confirm Admin Password The administrator password, entered a second time to confirm.
Folder (Optional.) The name of the folder in which to place this Access
Controller.
Pull down the list to select a folder. By default the Access Controller
is placed in the Default folder.
See —Folders vs. Locations“ on page 6-14 for more information on
Folders.
Enable HP ProCurve technical support
access
(Optional.) A check in this checkbox enables access by the
Technical Support personnel at HP ProCurve to this Access
Controller.
Note: Enable this feature only if directed to do so by your HP
ProCurve Technical Support contact.
Enable SSH command line interface (Optional.) A check in this checkbox enables remote access to the
Command Line Interface for this Access Controller via SSH. This
requires that the client system running the CLI supports SSH.
If this checkbox is not checked, remote access to the CLI is disabled.
The CLI can be accessed only over a direct connection to the serial
port on the Access Controller.
Access Control Server
Access Control Server IP The IP address of the Access Control Server (or Integrated Access
Manager) to which this Access Controller should be connected.
Shared Secret The shared secret used to validate this Access Controller to its
Access Control Server or Integrated Access Manager. It must match
exactly the shared secret configured on the Access Control Server or
Integrated Access Manager.
Confirm Shared Secret The shared secret, entered a second time to confirm.
6-12 HP ProCurve Secure Access 700wl Series Management and Configuration Guide