Filter
Top Products
System Maintenance
If you enable Auto Refresh, the status page refreshes approximately every 15 seconds, displaying
updated status information. After the download and unpack operations are complete, a
completion message appears:
New image successfully installed.
If you specified an automatic restart, the status message also displays Initiating reboot and the
restart operation starts.
Step 4. If you did not specify an automatic restart, you can return to the Update Software page as soon as
the download has completed to perform another upgrade on a different unit.
The Software Setup tab displays both the installed software version as well as an alternate
version, which should be the newly-downloaded version. You must then restart to the alternate
version to complete the update of the software.
Step 5. To initiate a restart of the unit, return to the Software Setup tab and select Restart to Alternate
Software
.
When the system has restarted, the newly-downloaded version should appear as the Installed
Version under the Software Setup tab. The previously installed version should appear as the
Alternate Version.
Caution: Restarting an Access Control Server or Integrated Access Manager will log off all clients on all
Access Controllers. If possible, you should perform an upgrade and restart during a time when clients
are not actively connected.
Support for Alternate Download Sites
By default the download URL specifies the location of an HP ProCurve FTP server site where the most
recent upgrade images are stored. If for any reason you cannot or do not wish to download software
images from the HP ProCurve download FTP site, it is possible to obtain the software images and install
them on your own FTP, TFTP, or HTTP site.
Note: To download the software image to a local FTP, HTTP, or TFTP server, please go to
www.hp.com/go/hpprocurve.
If you know that the download images are stored on a different server, you can enter your URL in any
one of these URL formats:
•
<protocol>://<host>/<update_file>
• <protocol>://<username>[:<password>]@<host>/<update_file>
where the variables in those formats can be as follows:
Variable Value
protocol FTP, HTTP, or TFTP
host IP address or a server hostname
host can include a port–hostname:port–following the host name and
separated by a colon
username[:password] Username and password with access to the remote site, if required
8-8 HP ProCurve Secure Access 700wl Series Management and Configuration Guide