Filter
Top Products
Command Line Interface
cancel upgrade
Cancels the current get upgrade task.
set upgradeproxy [on | off] [host <ip-address> [<port> ] ] [user <user> [<password> ] ]
Configure a proxy server for retrieving software releases via FTP.
on | off Enables and disables the proxy server.
<ip-address> Specifies the proxy server IP address
<port> (Optional) TCP port for the proxy server. Default is 3128.
<user > (Optional) User name needed for access to proxy server
<password> (Optional) User password
clear upgradeproxy
Resets the proxy server settings used for retrieving software releases via FTP.
show upgradeproxy
Shows the current upgrade proxy server configuration. The following is an example of the output
when no proxy is set:
Upgrade Proxy settings
Proxy enabled: No
Host IP: Not set
Port: 3128
User: Not set
Password: Not set
Stopping and Restarting the System
reboot [upgrade | downgrade | same]
Restarts the system.
Optionally, you can specify that the reboot should use the alternate version of the system software.
The alternate version installed on the system must match the type you specify. For example, if the
alternate version is a newer version than the current version, it is type upgrade. If the alternate
version is an older version, it is type downgrade.
Use the
show version command to determine the type of the alternate version.
You are prompted to confirm that you want to reboot.
upgrade Reboot using the alternate version, which is a newer version than the
currently active system software.
downgrade Reboot using the alternate version, which is an older version than the
currently active system software.
same Reboot using the alternate version, which is the same version as the
currently active system software.
HP ProCurve Secure Access 700wl Series Management and Configuration Guide A-29