Filter
Top Products
101
Chapter 3 Port Configuration
3.1 Introduction to Port
The front panel of ES4626 provide 4 Combo ports (these Combo ports can be configured as
either 1000MB copper ports or 1000MB SFP fiber ports, but only one type can be selected), 20
1000MB copper ports and 2 XFP 10GB fiber port.
If the user need to configure some network ports, he/she can use the “interface ethernet
<interface-list>” command to enter the appropriate Ethernet port configuration mode, where
<interface-list> stands for one or more ports. If <interface-list> contains multiple ports,
special characters such as “;” or “-” can be used to separate ports. “;” is used for discrete port
numbers and “-” is used for consecutive port number. Suppose operation should be performed
to ports 2, 3, 4, 5, the command can look like this: interface ethernet 1/2-5. Port speed,
duplex mode and traffic control can also be configured under Ethernet Port configuration Mode,
and the performance of the corresponding physical network ports will change accordingly.
3.2 Port Configuration
3.2.1 Network Port Configuration
3.2.1.1 Network Port Configuration Task Sequence
1. Enter the network port configuration mode
2. Configure the properties for the network ports
Configure the combo mode for combo ports
Enable/Disable ports
Configure port names
Configure port cable types
Configure port speed and duplex mode
Configure bandwidth control
Configure traffic control
Enable/Disable port loopback function
Configure broadcast storm control function for the switch
1. Enter the Ethernet port configuration mode