Filter
Top Products
498
Click Set router as RP candidate. Users can configure candidate RP for PIM-SM. See
the equivalent CLI command at 16.4.2.2.5:
Set router as RP candidate – “yes” is used to set the switch as RP candidate; “yes” is
used to cancel the switch as RP candidate
Port – Specify layer 3 VLAN ID
Group-List – Specify access-list number
Interval – Specify interval of sending candidate RP messages
Apply – Apply the configuration
16.7.4 DVMRP configuration
In DVMRP configuration mode, users can enable DVMRP or disable DVMRP protocol
on the port. See the equivalent CLI command at 16.5.2.2.2:
Enable DVMRP – “yes” is used to enable DVMRP protocol; “no” is used to disable
DVMRP protocol
Vlan Port - Specify the layer 3 port
Apply – Apply the configuration
Default – Disable DVMRP protocol
Click Cisco-compatible configuration. Users can enable Cisco-compatible. See the
equivalent CLI command at 16.5.2.2.1:
Cisco neighbor’s IP address – Specify Cisco neighbor’s IP address
Vlan Port - Specify the layer 3 port
Apply – Apply the configuration
Default – Disable Cisco-compatible