Filter
Top Products
117
cable is support; normal means that only the straight cable is
support. See the equivalent CLI command at 3.2.1.2.6
& Admin Status – Enable or disable port. See the equivalent CLI
command at 3.2.1.2.9
& speed/duplex status – Set port duplex. The supported types
include: auto, 10M/Half, 10M/Full, 100M/Half, 100M/Full,
1000M/Half and 1000M/Full. See the equivalent CLI command at
3.2.1.2.2 and 3.2.1.2.10
& port flow control status – Configure port flow control. See the
equivalent CLI command at 3.2.1.2.3
& Loopback – Set to allow or not to allow loopback test. See the
equivalent CLI command at 3.2.1.2.5
For example: Specify port as Ethernet1/1; set mdi to normal; set Admin Status to no
shutdown; set speed/duplex status to auto; set port flow control status to Invalid flow
control; set Loopback to no loopback, and then click Apply. The configuration is applied on
the port 1/1.
The switch port information is shown in post list page:
3.5.1.2 Bandwidth control