Filter
Top Products
387
SwitchC(Config)# interface vlan 2
SwitchC(Config-If-vlan2)# ip address 20.1.1.2 255.255.255.0
SwitchC (c config-If-vlan2)#exit
！Enable RIP
SwitchC(Config)#router rip
SwitchC(Config-router-rip)#exit
！Enable vlan2 to send/receive RIP packets
SwitchC(Config)#interface vlan 2
SwitchC (Config-If-vlan2)#ip rip work
SwitchC (Config-If-vlan2)exit
SwitchC(Config)#exit
SwitchC#
15.3.4 RIP Troubleshooting Help
1. Monitor and Debug Commands
2. RIP Troubleshooting Help
15.3.4.1 Monitor and Debug Commands
Command Explanation
Admin Mode
show ip rip
Display the current running status and
configuration information for RIP. The user
can decide whether the configurations are
correct or not and perform RIP
troubleshooting according to the output of this
command.
show ip route
Display route table information, RIP routing
information can be checked.
show ip protocols Displayed protocol information
[no] debug ip rip packet Display all RIP packets received and sent.
[no] debug ip rip recv Display all RIP packets received
[no] debug ip rip send Display all RIP packets sent.
（1）show ip rip
Displayed information:
RIP information:
Automatic network summarization is not in effect.
default metric for redistribute is : 16
neigbour is : NULL