Filter
Top Products
373
ip rip receive version {1 | 2 | 1 2}
no ip rip receive version
Sets the version of RIP packets to receive on
all ports; the “no ip rip receive version”
command restores the default, i.e., receive
both v1 and v2 packets, enables receiving RIP
packets on the interface.
ip rip receive version none
Disables receiving RIP packets on the
interface
ip rip send version none Disables sending RIP packets on the interface
4. Disable RIP
Command Explanation
Global Mode
no router rip
Disables RIP
RIP (Routing Information Protocol) is a dynamic interior routing protocol based on
distance vector. It is widely used for its simple configuration. RIP exchanges routing
information by UDP packet advertisement, route update information is sent every 30
seconds. It uses hop number to be the standard of choosing route, route of fewer hops to
the same destination network will be chosen first. The maximum hop number allowed is
16, so RIP is suitable for autonomous system with relative smaller diameter. RIP
configuration commands are mainly used in Global Mode, RIP configuration mode,
Interface Mode and Admin Mode.
15.3.2.2 RIP Configuration Commands
z auto-summary
z default-metric
z ip rip authentication key
z ip rip authentication mode
z ip rip metricin
z ip rip metricout
z ip rip receive version
z ip rip receive version none
z ip rip send version
z ip rip send version none
z ip rip work
z ip split horizon
z redistribute
z rip broadcast
z rip checkzero
z rip preference