Filter
Top Products
438
15.5.2.7 RIP timer configuration
Click RIP timer configuration. The configuration page is shown. See the equivalent CLI
command at 15.3.2.2.18
The explanation of each field is as below:
Update timer – Update packet timer
Invalid timer – RIP route invalid timer
Holddown timer – Time length of a route which can stay in the route table after it is invalid.
For example: Set each field and then click Apply.
15.5.3 OSPF
Click OSPF configuration. Users can configure OSPF:
OSPF enable – Enable OSPF protocol
OSPF Tx-parameter configuration – Configure OSPF transmitting parameters
Imported route parameter configuration – Configure OSPF imported route parameters
Other parameter configuration – Configure other OSFP parameters
OSPF debug - OSPF debug information
15.5.3.1 Enable OSPF
Click OSPF enable. The configuration page is shown:
OSPF enable – Enable/disable OSPF
Router-ID configuration – Configure Router-ID for the switch
OSPF network range configuration – Configure OSPF network range
OSPF area configuration for port – Configure OSPF area for the port