Filter
Top Products
255
Target port – Specify the target port
For other protocols, the following fields need to be configured:
Matched protocol – Specify the matched protocol: IP, EIGRP, OSPF, IPINIP and Input
protocol manually. When “Input protocol manually, users can imput protocol number.
For example: Configure an extended ACL numbered 110 which denies the TCP packets
with the source address as 10.0.0.0/24 and target port as 21. Set ACL number (100-199)
to 110; set Rule to deny; set Source address type to Specified IP address; set Source IP
address to IP10.0.0.0; set Reverse network mask to 0.0.0.255; set Target address type to
Any; set Target port to 21, and then click Add.
9.5.4 Standard ACL name configuration
Click ACL name configuration. Standard ACL name configuration page is shown. The
configuration is very similar to standard numeric ALC configuration, but ACL number field
is replaced by ACL name field. See the equivalent CLI command at 9.2.2.6
The explanation of each field is as below:
ACL name – Specify ACL name
ACL type – Specify ACL type: standard and extended
Rule – permi or deny