Filter
Top Products
520
18.2.2.6 cluster auto-add
Command: cluster auto-add enable
no cluster auto-add enable
Function: When this command is executed in the commander switch, the newly
discovered candidate switches will be added to the cluster as a member switch
automatically; the “no cluster auto-add enable” command disables this function.
Command mode: Global Mode
Default: This function is disabled by default. That means that the candidate switches are
not automatically added to the cluster.
Usage Guide: When this command is executed in the commander switch and the
commander switch receives the cluster registration packets sent by the new
switch, the commander switch adds the candidate switch to the cluster. If this
command is executed in a non-commander switch, an error will be displayed.
Example: Enable the auto adding function in the commander switch.
Switch(config)#cluster auto-add enable
18.2.2.7 rcommand member
Command: rcommand member <mem-id>
Function: In the commander switch, this command is used to remotely manage the
member switches in the cluster.
Parameter: <mem-id> is the cluster ID of the member switch, valid rang is 1 to 23.
Command mode: Admin Mode
Usage Guide: Enter the Admin Mode of the member switch and configure the member
switch remotely. Use “exit” to quit the configuration interface of the member
switch. If this command is executed in a non-commander switch, an error will be
displayed.
Example: In the commander switch, enter the configuration interface of the member
switch with mem-id 15.
Switch#rcommand member 15
18.2.2.8 rcommand commander
Command: rcommand commander
Function: In the member switch, use this command to configure the commander switch.
Command mode: Admin Mode