Filter
Top Products
339
z Default－Will back to startup setting. This command will modify the configuration.
The parameter will take effect alternative port trust status and port priority.
To configure the port Ethernet 1/1 with trust mode, should set the packet by COS value
classification first and keep it without changing DSCP value. Choosing the Ethernet1/1
port and select the cos and pass-through-dcsp for Port trust status, then click Apply.
13.1.5.4.2 Port Default Cos Configuration
Click Port default CoS configuration to entry configure page. It is equivalent to CLI
command 13.1.2.2.11.
All sections describe as following:
z Port
z Default CoS value－Startup CoS value
z Reset－Will set column as startup defaults. This command will not modify the
configuration.
z Apply－Will take effort to all setting. This command will modify the configuration.
z Default－Will back to startup setting. This command will modify the configuration.
If would like to set the cos value 5 in port Ethernet 1/1. Selecting port Ethernet1/1, input
value 5 in Default CoS, then click Apply.
13.1.5.4.3 Apply Policy-map to Port
Click Apply policy-map to port to entry the configure page. It is equivalent to CLI command
13.1.2.2.12.
All sections describe as following:
z Port
z Policy-map name
z Port direction－Input or Output