Filter
Top Products
23
Mode, it will also return to the Admin Mode. ES4626/ES4650 also provides a shortcut key
sequence "Ctrl+z”, this allows an easy way to exit to Admin Mode from any configuration
mode (except User Mode).
Under Admin Mode, when disable command is run, it will return to User Mode. When
exit command is run, it will exit the entry and enter user entry system direct. Next users
can reenter the system on entering corresponding user name and password.
Under Admin Mode, the user can query the switch configuration information,
connection status and traffic statistics of all ports; and the user can further enter the Global
Mode from Admin Mode to modify all configurations of the switch. For this reason, a
password must be set for entering Admin mode to prevent unauthorized access and
malicious modification to the switch.
1.2.1.1.3 Global Mode
Type the config command under Admin Mode will enter the Global Mode prompt
“Switch(Config)#”. Use the exit command under other configuration modes such as
Interface Mode, VLAN mode will return to Global Mode.
The user can perform global configuration settings under Global Mode, such as MAC
Table, Port Mirroring, VLAN creation, IGMP Snooping start, GVRP and STP, etc. And the
user can go further to Interface Mode for configuration of all the interfaces.
1.2.1.1.3.1 Interface Mode
Use the interface command under Global Mode can enter the interface mode
specified. ES4626/ES4650 provides three interface type: VLAN interface, Ethernet port
and port-channel, and accordingly the three interface configuration modes.
Interface Type Entry Prompt Operates Exit
VLAN
Interface
Type interface
vlan <Vlan-id>
command under
Global Mode.
Switch(Config-If-
Vlanx)#
Configure
switch IPs, etc
Use the exit
command to
return to
Global Mode.
Ethernet Port Type interface
ethernet
<interface-list>
command under
Global Mode.
Switch(Config-
ethernetxx)#
Configure
supported
duplex mode,
speed, etc.
of Ethernet
Port.
Use the exit
command to
return to
Global Mode.
port-channel Type interface Switch(Config-if- Configure Use the exit