Filter
Top Products
91
2.6.2 SNMP Configuration
Click Switch Basic Configuration, SNMP Configuration. The switch SNMP
configuration is shown. Users can configure SNMP.
2.6.2.1 SNMP manager configuration
Click Switch Basic Configuration, SNMP Configuration, SNMP manager configuration.
Configure switch community string. See the equivalent CLI command at 2.4.4.2.2
& Community string (0-255 character) - Configure community string
& Access priority - Specify access mode to MIB. There are two options: Read only
and Read and write.
& State - Valid means to set; Invalid means to delete
For example: Set Community string to qiantu; set Access priority to Read only; set
State to Valid, and click Apply. The configuration is applied on the switch.
2.6.2.2 TRAP manager configuration
Click Switch Basic Configuration, SNMP Configuration, TRAP manager configuration.
Users can configure the IP address and Trap community string of the NMS to receive
SNMP trap message. See the equivalent CLI command at 2.4.4.2.5
& Trap receiver - IP address of NMS to receive Trap messages
& Community string (0-255 character) - Community string used in sending Trap
message
& State - Valid means to set; Invalid means to delete
For example: Set Trap receiver to 41.1.100, set Community string to kevin, set State
to Valid, and then click Apply. The configuration is applied on the switch.