Filter
Top Products
435
the equivalent CLI command at 15.3.2.2.11
The explanation of each field is as below:
Port – Port name
Enable port to receive/transmit RIP packet – set; cancel
For example: Disable to receive/transmit RIP packet on vlan2. Select vlan1; select vlan1;
select cancel, and then click Apply.
15.5.2.3 Configuring import routes generated by other
routing protocols to RIP
Import routes generated by other routing protocols to RIP
Click Enable imported route. See the equivalent CLI command at 15.3.2.2.13
The explanation of each field is as below:
Import other routing protocol to RIP – Protocol imported: Static, OSPF and BGP
Redistribute imported route cost – Route cost
Operation type – Add or Remove
For example: Import OSPF route with cost of 5 to RIP. Set Import other routing protocol to
RIP to OSPF; set Redistribute imported route cost (1-16) to 5, and then click Apply.
15.5.2.4 Port metric in/out configuration
Click Metric in/out configuration. The configuration page is shown.
The explanation of each field is as below:
In – Metric for received RIP packets. See the equivalent CLI command at 15.3.2.2.5
Out – Metric for sent RIP packets. See the equivalent CLI command at 15.3.2.2.6
Port – Specify the port
For example: Set In to 2; set Out to 3; set Port to Vlan1, and then click Apply.