Filter
Top Products
22
z Input verification
z Fuzzy match support
1.2.1.1 Configuration Modes
Fig 1-12 Shell Configuration Modes
1.2.1.1.1 User Mode
On entering the CLI interface, entering user entry system first. If as common user, it is
defaulted to User Mode. The prompt shown is “Switch>”, the symbol “>” is the prompt for
User Mode. When disable command is run under Admin Mode, it will also return to the
User Mode.
Under User Mode, no configuration to the switch is allowed, only clock time and
version information of the switch can be queries.
1.2.1.1.2 Admin Mode
To enter Under Admin Mode see the following: In user entry system, if as Admin user,
it is defaulted to Admin Mode. Admin Mode prompt “Switch#” can be entered under the
User Mode by running the enable command and entering corresponding access levels
admin user password, if a password has set. Or, when exit command is run under Global
User Mode
Admin Mode
Global Mode
Interface Mode
Vlan Mode
DHCP address pool
configuration mode
Route configuration
mode
A
CL configuration
mode