Filter
Top Products
116
duplex mode, traffic control on/off, broadcast storm control and statistics for packets
sent/received. Usage Guide: If no port is specified, then information for all ports will be
displayed.
Example: Display information about port 4/1.
Switch#show interfaces status ethernet 4/1
3.4.2 Port Troubleshooting Help
Here are some situation frequently occurs in port configuration and the advised
solutions:
& Two connected fiber interfaces won’t link up if one interface is set to auto
negotiation but the other to forced speed/duplex. This is determined by IEEE
802.3.
& The following combinations are not recommended: enable traffic control as well
as set multicast limit for the same port; set broadcast, multicast and unicast for
unknown destination control as well as port bandwidth limit for the same port. If
such combinations are set, the port throughput may fall below the expected
performance.
3.5 WEB Management
Click Port configuration, the port configuration page is shown. Users can configure
switch ports features such as port speed and port duplex etc.
3.5.1 Ethernet port configuration
Click Port configuration, Ethernet port configuration. The Ethernet port configuration
page is shown. Users can configure Ethernet ports features, such as port speed, port
duplex and bandwidth control etc.
3.5.1.1 Physical port configuration
Click Port configuration, Ethernet port configuration, Physical port configuration. The
following port features can be configured:
& Port - Specify the port
& mdi – Set the supported cable types on the Ethernet port. Auto
means automatic detected; across means that only the crossover