Filter
Top Products
497
PIM-SM protocol.
Vlan Port - Specify the layer 3 port
Apply – Apply the configuration
Default – Disable PIM-SM on the layer 3 interface
Click PIM-SM parameter configuration. Users can configure PIM-SM parameters on
the layer 3 port. See the equivalent CLI command at 16.4.2.2.3:
Hello-Interval – Specify PIM-SM hello interval on the port
Vlan Port – Specify layer 3 vlan port
Apply – Apply the configuration
Default – Restore the default PIM-SM hello interval on the port
Click Set interface as PIM-SM BSR border. Users can configure the border port of
PIM-SM area which can prevent BSR messages from advertising outside the PIM-SM
area. See the equivalent CLI command at 16.4.2.2.2:
Vlan Port - Specify the layer 3 port
Apply – Apply the configuration
Default – Disable the port as PIM-SM area border
Click Set router as BSR candidate. Users can configure candidate BSR for PIM-SM.
See the equivalent CLI command at 16.4.2.2.4:
Set router as BSR candidate – “yes” is used to enable the switch as candidate BSR
for PIM-SM; “no” is used to disable the switch as candidate BSR for PIM-SM
Port – Specify layer 3 VLAN ID
Hash mask length – Specify hash mask length
Priority – Specify priority
Apply – Apply the configuration