Filter
Top Products
440
15.5.3.1.4 Configure OSPF area for port
Click OSPF area configuration for port. The configuration page is shown. See the
equivalent CLI command at 15.4.2.2.9
The explanation of each field is as below:
Vlan port – Vlan port list
Area ID – Area ID
Reset – Reset
Default – Restore the default value
For example: Set the port Vlan1 to belong to area 1; Set Vlan port to Vlan1; set Area ID to
1, and then click Apply.
15.5.3.2 OSPF transmitting parameters configuration
Click OSPF Tx-parameter configuration. Users can configure OSPF transmitting
parameters:
OSPF authentication parameter configuration – Configure OSPF authentication
parameter
Passive interface configuration – Set OSPF port to receive, but not to transmit
Sending packet cost configuration – Configure Sending packet cost for port
15.5.3.2.1 OSPF authentication parameter configuration
Click OSPF authentication parameter configuration. The configuration page is shown. See
the equivalent CLI command at 15.4.2.2.6
The explanation of each field is as below:
Vlan port – Vlan port list
Authentication mode – Configure authentication mode: simple or MD5
Authentication key – Configure authentication key
KeyID - MD5 KeyID