Filter
Top Products
496
packets forwarding. See the equivalent CLI command at 16.2.1.1.1. Users don’t need to
configure the parameters. For the detailed explanation of the displayed information, see
chapter 16.2.1.1.1
16.7.2 PIM-DM configuration
In PIM-DM configuration mode, users can enable PIM-DM or disable PIM-DM
protocol on the port. See the equivalent CLI command at 16.3.2.3:
Enable PIM-DM – “yes” is used to enable PIM-DM protocol; “no” is used to disable
PIM-DM protocol.
Vlan Port - Specify the layer 3 port
Apply – Apply the configuration
Default – Disable PIM-DM on the layer 3 interface
Click PIM-DM parameter configuration. Users can configure PIM-DM parameters on
the layer 3 port. See the equivalent CLI command at 16.3.2.4:
Hello-Interval – Specify PIM-DM hello interval on the port
Vlan Port – Specify layer 3 vlan port
Apply – Apply the configuration
Default – Restore the default PIM-DM hello interval on the port
16.7.3 PIM-SM configuration
In PIM-SM configuration mode, users can enable PIM-SM or disable PIM-SM
protocol on the port. See the equivalent CLI command at 16.4.2.2.1:
Enable PIM-SM – “yes” is used to enable PIM-SM protocol; “no” is used to disable