Filter
Top Products
224
8.2.2.19 radius-server dead-time
Command: radius-server dead-time <minutes>
no radius-server dead-time
Function: Configure the recover time after RADIUS server dead; use the “no” command
to restore default configuration.
Parameter: <minutes>is the recover time after RADIUS server dead in minutes, The
range: 1~255.
Command mode: global configuration mode
Default: Default is 5 minutes.
Instructions: This command specifies the switch wait time which from “cannot access”
status restore to ”be able to access” status of the RADIUS server. When switch checked
the server cannot be able to access, switch will configure the server status as invalid
status, after exceed the above configuration interval time, system will configure the
authentication server status as valid.
Example: Configure RADIUS server dead time as 3 minutes.
Switch(Config)#radius-server dead-time 3
8.2.2.20 radius-server key
Command: radius-server key <string>
no radius-server key
Function: Configure RADIUS server (including authentication and accounting)
authentication key; use the “no” command to remove RADIUS server of authentication
key.
Parameter: <string> is RADIUS server authentication key string, range cannot exceed
16 characters.
Command mode: global configuration mode
Instructions: This authentication key for switch configure RADIUS server to
authenticate message communication. The configured authentication key must be the
same as authentication key which configured in RADIUS server, otherwise it will not
make correct RADIUS authenticate and accounting.
Example: Configure RADIUS authentication key as test.
Switch(Config)# radius-server key test
8.2.2.21 radius-server retransmit
Command: radius-server retransmit <retries>
no radius-server retransmit