Filter
Top Products
338
Click Apply aggregate policer to entry the configure page. It is equivalent to CLI command
13.1.2.2.9.
All sections describe as following:
z Aggregate policer name
z Policy-map name
z Class-map name
To apply the aggregate policer agg1 by c1 class-map, input the graphic presentation value,
then click Add.
13.1.5.4 Apply QoS to Port
Click Apply QoS to port to entry the configure page, including four sections:
z Port trust mode configuration
z Port default CoS configuration
z Apply policy-map to port
z Apply DSCP mutation mapping
13.1.5.4.1 Port Trust Mode Configuration
Click Port trust mode configuration to entry the configure page. It is equivalent to CLI
command 13.1.2.2.10.
All sections describe as following:
z Port
z Port trust status－including
9 cos, cos and pass-through-dcsp,
9 dcsp, dcsp and pass-through-cos,
9 ip-precedence, ip-pre and pass-through-cos
z Port priority
z Reset－Will set column as startup defaults. This command will not modify the
configuration.
z Apply－Will take effort to all setting. This command will modify the configuration.