Filter
Top Products
499
Click DVMRP parameter configuration. Users can configure DVMRP interface
parameters: See the equivalent CLI command at 16.5.2.2.4 and 16.5.2.2.5:
Vlan Port - Specify the layer 3 port
DVMRP report metric configuration – Configure DVMRP report metric for the port.
See the equivalent CLI command at 16.5.2.2.4
DVMRP neighbor timeout configuration – Configure DVMRP neighbor timeout for the
port. See the equivalent CLI command at 16.5.2.2.5
Apply – Apply the configuration
Default – Restore the default settings on the port (DVMRP report metric and DVMRP
neighbor timeout)
Note: This page is related to two CLI commands. When users only set one parameter,
there is a warning for not configuring the other parameter. The configuration is still valid.
Click DVMRP global parameter configuration. Users can configure global DVMRP
parameters. See the equivalent CLI command at 16.5.2.2.3, 16.5.2.2.6, 16.5.2.2.7 and
16.5.2.2.8:
DVMRP graft interval configuration – Configure DVMRP graft interval. See the
equivalent CLI command at 16.5.2.2.3
Interval of sending probe packet – Configure Interval of sending probe packet. See
the equivalent CLI command at 16.5.2.2.6
Interval of sending report packet – Configure Interval of sending report packet. See
the equivalent CLI command at 16.5.2.2.7
DVMRP route timeout – Configure DVMRP route timeout. See the equivalent CLI
command at 16.5.2.2.8
Apply – Apply the configuration
Default – Restore the default settings (sending graft, probe, report interval, dvmrp
route timeout)
Note: This page is related to four CLI commands. When users only set one parameter,
there is a warning for not configuring other parameters. The configuration is still valid.