Filter
Top Products
157
5.3.2.3 garp timer hold
Command: garp timer hold <timer-value>
no garp timer hold
Function: Set the hold timer for GARP; the “ no garp timer hold” command restores the
default timer setting.
Parameter: < timer-value> is the value for GARP hold timer, the valid range is 100 to
327650 ms.
Command mode: Interface Mode
Default: The default value for hold timer is 100 ms.
Usage Guide: When GARP application entities receive a join message, join message
will not be sent immediately. Instead, hold timer is started. After hold timer timeout, all
join messages received with the hold time will be sent in one GVRP frame, thus
effectively reducing protocol message traffic.
Example: Set the GARP hold timer value of port 1/10 to 500 ms.
Switch(Config-Ethernet1/10)#garp timer hold 500
5.3.2.4 garp timer leaveall
Command: garp timer leaveall <timer-value>
no garp timer leaveall
Function: Set the leaveall timer for GARP; the “ no garp timer leaveall” command
restores the default timer setting.
Parameter: < timer-value> is the value for GARP leaveall timer, the valid range is 100 to
327650 ms.
Command mode: Global Mode
Default: The default value for leaveall timer is 10000 ms.
Usage Guide: When a GARP application entity starts, the leaveall timer is started at the
same time. When leaveall timer timeout, the GARP application entity will send a leaveall
message. Other application entities will cancel all property information for that application
entity, and the leaveall timer is cleared for a new cycle.
Example: Set the GARP leaveall timer value to 50000 ms.
Switch(Config)#garp timer leaveall 50000
5.3.2.5 bridge-ext gvrp
Command: bridge-ext gvrp